919739844276 919739844276
G-Tech Consultants


  • Shell & Tube Heat Exchanger Designing
    Shell & Tube Heat Exchangers are most commonly used equipment. Shell & Tube Heater Exchanger construction can be of fixed tube sheet, U-tube or floating head type. Typical applications are : Hydraulic oil/Turbine oil/Quench oil cooler. Boiler feed water preheater. Gland steam condenser. Binary

    Enquiry Now

    Shell & Tube Heat Exchanger Designing

  • Helical Coil Heat Exchanger Designing
    Helical Coil Heat Exchanger has many advantages over other heat exchangers : Where space is limited, so that not enough straight pipe can be laid. Where flow rates are low, other heat exchangers would become uneconomical. Helical coils can be installed inside tanks or vessels. Typical

    Enquiry Now

    Helical Coil Heat Exchanger Designing

  • Air Cooled Heat Exchanger Designing
    Air-cooling has many advantages over water-cooling : Air cooler can be located anywhere, unlike water cooler which has to be near water source. Maintenance cost of air cooler is lower than that of water cooler. Typical applications are : Hydraulic oil cooer Turbine oil cooer Pentane vapour

    Enquiry Now

    Air Cooled Heat Exchanger Designing

  • Pressure Vessel Designing

    We follow ASME Sec.VIII Div.1 code and IS 2825 standard.

    Typical applications are :

    • Refrigerant receiver
    • Air receiver

    Enquiry Now

    Pressure Vessel Designing

  • Electric Heater Designing
    Virtually all the heat generated by Electric Heater is transferred into the medium. Thus an Electric Heater is nearly 100 percent efficient. Using heating element manufactured by customer, we can provide design for electric heaters in various forms.Typical applications are : Fuel oil / Lube oil

    Enquiry Now

    Electric Heater Designing

  • Skid Mounted System

    The System is assembled on a skid at the factory and transported to site.
    At the site,the skid mounted system can be quickly commissioned.

    Enquiry Now

    Skid Mounted System